Brush clean pot

Brush clean can

After each painting craft the Brushes They are cleaned with water or strong products to remove all impurities and paint residues and then, we leave them resting to dry. Thus, the only thing we get is that the bristles are bent and then cannot be reused.

Therefore, today we present this manual to solve it. It will be a metal boat in which we can place, vertically our brushes, so that they dry and then can be used again, since the bristles do not bend.

Materials

  • 1 l metal jar.
  • Pushpin.
  • Cutting pliers.
  • Metallic spring.
  • Pointed pliers.

Our Process

Firstly, we will perfectly clean the metal pot. Afterwards, we will sand the inner mouth of the can to avoid cutting ourselves.

Then, with the help of the thumbtack, we will drill two opposite ends of the mouth of our boat, to be able to place the spring.

Subsequently, we will measure the width of the pier from one end to the other and we will cut the excess with the cutting pliers.

Next, we will introduce both ends of the spring through the holes of the boat that we had done previously, helping us with the nose pliers to twist the spring so that it is well fixed.

Finally, we just have to introduce our wet brushes between the spring rings to dry completely.


Be the first to comment

Leave a Comment

Your email address will not be published. Required fields are marked with *

*

*

  1. Responsible for the data: Miguel Ángel Gatón
  2. Purpose of the data: Control SPAM, comment management.
  3. Legitimation: Your consent
  4. Communication of the data: The data will not be communicated to third parties except by legal obligation.
  5. Data storage: Database hosted by Occentus Networks (EU)
  6. Rights: At any time you can limit, recover and delete your information.