How to create a bear with a flower made with fimo or polymer clay

With this tutorial, learn to model a bear with fimo or with any type of polymer clay. This figure also has a flower and a bug on its foot, so you can take it as a 3 in 1, because I teach you to do everything.

Colours

To make the bear figure with all its accessories you will need the following colors:

Brown
Flesh color (white + orange)
Black
Blanco
Verde
Yellow

Step by step

Start with the bear. To make the body, model a drop from a ball. Roll the ball on one side and you will see how it stretches until it is in the shape of a drop. Flatten the bottom so the bear stands up.

To make the feet, create two drops in the same way as the body, and mark them with the fingers with the knife. Glue them to the sides of the body.

For the arms it is the same procedure. Glue them by the thin part on the sides of the neck.

The head is an oval, so you should roll a ball very smoothly until it elongates a bit. Lay it flat on the bear's neck.

The muzzle is going to be flesh-colored. Make a ball and again another oval, and flatten it well. Glue it on the bear's face.

Make all the details of the face. One black ball for the nose and two small balls for the eyes. You can also mark the eyebrows with the knife. And finally, crush two brown balls and use them as ears.

Do not forget to put the tail with a brown ball.

It's time to make the flower. To do this, create two drops from two green balls. Squash the drops and mark the lines on the leaves.

For the flower you will need 6 balls of the same color. Put them together as if it were a maggot, and join the first with the last, thus closing a circle. Glue a yellow ball in the center.

Gather the flower with the leaves and glue them to the bear.

The bug on its foot is very small, be guided by the size of your bear's foot. To make the body, make a yellow ball and a black ball that is half as large as the other. Smash the black one and stick it on the yellow one.