At DIY today we are going to see how to make a knot bracelet. It seems very complicated, but you just have to follow a few tricks, because if you realize it, the same pattern is always repeated from the beginning to the end.
The funny thing is you can change and combine the colors you like the most, make it wider or narrower, depending on what you want it to be. Let's go with the step by step ...
Makings:
To make this bracelet we are only going to need thread y scissors:
- Once the colors of our threads have been chosen we will cut approximately 90 cm. I have used two threads of each color ... but if you want it to be wider or narrower you can put more or less threads.
- We put all the threads together, we will leave about 10 cm and we will fasten it to a surface I have done it with an adhesive tape, but you can tie it to a chair or have someone hold it for you!
- We will separate all the threads and place them according to our composition. as indicated in the picture.
- We start with the knots. We take the first thread and make two knots on each of the threads until we finish with the threads and go to the other side.
- As you see in the image the first thread that was previously on the left, is now on the right.
- We do the same with the following thread and so with the rest. (It is always following this same pattern).
- As seen in the image stripes will come out of the different colors that we have put.
- We will continue like this until we see the appropriate measurement for our wrist.
- We will finish by making a braid to the two ends to tie the bracelet.
I hope you liked it and that you practice with the colors that you like the most.